To operate a DC load incorporating the use of proximity sensor and counter circuit
Components
Timer
.png)
DC Load
PNP Sensor
Supply
Control circuit
.png)
.png)
Power circuit
.png)
.png)
.png)
Instructions
1. Click on the Control Circuit button in Control Circuit Section.
2. Get the required components in Control Circuit Section by clicking on components displayed in Components Section.
3. Establish the connections according to the control circuit diagram provided in Fig. (a).
4. Verify the control circuit by clicking on the Check Connections 1 button.
5. If Wrong Connections then click on Delete Connections 1 button to delete connections and make the right connections .
6. Once the Control Circuit is verified, switch to the Power Circuit Section.
7. Get the required components in Power Circuit Section by clicking on components displayed in Components Section.
8. Make the connections according to the Power Circuit diagram provided in Fig. (b).
9. Click on the Check Connections 2 button to validate the Power Circuit.
10. If Wrong Connections then click on Delete Connections 2 button to delete connections and make the right connections .
11. Once the Power Circuit is verified, switch On the Power Supplies.
12. Now enter the Count value (between 1-99) in the 'Set_Count' box.
13. Then drag the Coin over the PNP proximity sensor to increment the 'Actual_Count' value by 1 , repeat this according to the count value set by you.
14. To reset the 'Actual_Count' display value to "00", click on Counter's Reset button.
15. To reset the 'Set_Count' box value to "00" , Switch OFF & ON the Power Supply buttons.
16. Click on the Print button to get a print of the webpage.
17. Click on the Reset button to refresh the webpage .
[🔴 Red Endpoint Denote Positive terminal.]
[🔵 Blue Endpoint Denote Negative terminal.]
